|
Post by marcus3866 on Feb 14, 2008 9:50:56 GMT -5
Recently got the TopGun. Would like to use it with Time Crisis 2/3 and Virtuacop elite. Setup is PS2 and 42" Plasma screen. Have set up the gun and bars as per instructions. - Led bars are either side of the plasma screen and I am standing 3 metres back.
- I load the game and wait for it to start. No controllers connected.
- When the game starts I connect the Topgun.
- The Led Bar red light comes on, and the gun recoil and laser pointer works, however the game does not recognise the gun.
- I try and enter the calibration mode by pointing to the floor or ceiling and press A+B for 10 seconds, but the gun remains in normal mode (laser pointer appears on screen only - it is not flashing so there is good contact).
- The room is dark and all other light or IR sources are disabled.
Have tried all 3 games and 2 different PS2 units with no luck. Hope you can help. Thanks
|
|
|
Post by hkems on Feb 18, 2008 2:16:05 GMT -5
Please mind the followings and test again. In case it still not able to enter calibration mode, it should be defective. If so, please email to us. (sales@hkems.com) Before you connect the gun to PS2/PS3, please check if the switch (X/P) is at P. After you connect the gun to PC, pull the trigger and see if the gun would recoil and if the game would give you a BANG sound. Finally, hold A+B for 5-10 sec and see if it could enter the calibration mode. Thanks
|
|