|
Post by Taro on Jan 8, 2008 5:44:39 GMT -5
I want to play N64, using a gamecube control.
I installed the driver. (Do I need to do anything else?)
At first when I tried to configure the buttons, it selected something on its own immediately ("S0-") and wouldn't set anything else (always get "this selection is already in use").
Then I changed the "game device deadzone" (to 50%, it was at 20%) and the same thing happened with "Z+".
I got this problem with both a gamecube controller and a PS1 controller. Any way I can fix this problem? Is it a problem of Vista? I'm running vista with 1500RAM.
|
|
|
Post by Taro on Jan 8, 2008 8:08:24 GMT -5
P.S. When I go to "game controllers" in my control panel, EMS TrioLinker Plus II appears, but when I go to properties, it doesn't respond.
This happens with both PS and gamecube controllers.
I am running vista 32 bit.
|
|
|
Post by Taro on Jan 8, 2008 8:09:50 GMT -5
Also I made sure that I inserted the linker into USB AFTER I inserted the gamecube control in the linker.
|
|
|
Post by hkems on Jan 8, 2008 20:11:52 GMT -5
You are using our Trio Linker Plus II (#0603), right ? Would you please test the adaptor and your GC joypad on Windows XP without installing the driver ? Please go to the "control panel" --> "game options" and see if the joypad works well there. Thanks
|
|