Please follow the guide below to install and use the device.
important :
DO NOT swap nor skip any of the steps below.
Download and install the driver1. Download the driver from the link below.
www.hkems.com/files/0907/0907_v3.02.zip2. Unzip the file on desktop.
3. Follow the guide below to "sign" the .sys files. (ignore this if you are using x86 system)
www.hkems.com/files/EMSlink/64bit_Driver_Installation_Guide.pdf4. Visit "device manager"
5. Plug the device to PC. If windows pop up, close it and ignore it.
6. Right click the new recognized "unknown device" in the device manager. Select "install driver", an hardware installation wizard would pop up.
7. Let the wizard to search for the driver from the specific location. You could click "browse" to specify the location, please click it and direct it to the location of the folder "driver" in step 2.
8. If anything pop up, please click "Continue" / " Next" / "Allow" / "Yes" / "OK"...etc.
9. Reboot your PC.
10. Visit "device manager" again, you should able to find "EMS-interlink cable", and the driver installation is success. But, if there is "yellow interjection mark" beside it, it's abnormal and you should re-do all the above steps again.
Upgrade the firmware1. Close every EMS programs.
2. Run "v3.02_upgrade.exe".
3. Click the "Upgrade" button.
4. Disconnect the device, and close the program. (This is a MUST step. DO NOT ignore it.)
Backup / restore game saver1. Close every EMS programs.
2. Run "NDS_Adaptor_Plus_v3.02.exe".
3. Click "Card to PC" to backup game saver. Click "PC to Card" to restore game saver.
If you still can't install it, please inform us which step do you have problem with. Thanks.