New to forum, just received my RF TOPGUN, installed driver and although all seemed to go well, calibrating the gun, getting accuracy and a steady mouse have yet too arrived.
A little background; computer runs on Windows 7 64bit variety. As a display I’m using my 55 inch Visio LED display with the IR LED stands at left and right, with the RED LED’s at the upper right side.
I think is worth to mention that without touching any of the settings on the console the mouse only follows movement on a limited area of the screen. When I aim the gun outside this area the blue light on the D-Pad goes out. Did I mention the jerkiness of the mouse, WOW! Mind you all this and I have not run a game yet.
Please aim the gun at the four corners and the edges of the screen, check if the blue LED (inside D-pad) keeps solid blue.
If the blue LED turns off when you aim it near the edge, your gun should be too close to the screen. Please note that the distance between the gun and the screen should be around 2-3 times of that between the LED stands. If it flashes, there should be infrared interruption near where the gun is aiming at.
If the blue LED keeps solid blue in the above test, please follow the user manual to finish the hardware calibration.
Finally, please also note that other 2.4G Hz wireless device (e.g. wireless router) may interrupt the RF TopGun.
Hello I have the top gun 3 on a 64big PC. I downloaded the drivers and followed the steps to put the program in test mode then type in the file types of both .sys. Rebooted the PC then went into reinstall the drivers. I keep getting this error "Error attempting to install HID Mini Driver for EMS Top Gun, INF does not have digital signature. Please help I tried to re unlock those files a few times with no success
Remarks : 1. As TopGun driver is unsigned, it could not pass the "Driver Signature Enforcement" in win 8 64bit. Everytime after reboot, you have to re-do the above steps (except step 2) so as to disable "Driver Signature Enforcement" and install the driver again. 2. There may be some program to disable the "Driver Signature Enforcement" permanently in the future. If we find those method, we would inform you at once.
Man sign the driver it really your not doing your program justice with this s h i t.I don't want to use "Driver Signature Enforcement" it causes problems with some devices i have.Ffs 2 friends of mine didn't bought the gun cause of this problem.Can you please SIGN THE F***ING DRIVER?
Hi i bought the EMS topgun III and i have all the hardware plugged in.
I downloaded the 3 files needed from the video I founded to setup EMS topgun III on my 42inch LCD with window 7 64bit system. DSEO13b, Topgun_win7_64_beta and removewatermark.
My steps are run DSEO and enter test mode than add the 2 files hidmini.sys and hidtopgun.sys and reboot computer. After reboot I will run the removewatermark pressing Y and when finished enter. finally after that I run "Topgun panel" but when I load up the program the gun isn't listen on the side. Anyone know why? I installed this as admin and tried using " before and after the path and with out the " just the path to those 2 file but still nothing.
i have just purchased the ems3 and have download the necessary drivers for the gun to work with vista 32 bit. for some reason it cant install the mouse driver and says there is an error, so it comes up as "unidentified driver" whats the go here, i have tried everything. even installed the program to remove signatures. I have also tried the 64bit drivers too??? Cheers mark
As you are running Vista 32bit, this problem is nothing to do with the driver signature.
A possible problem is that you have directed the driver installation wizard to a wrong location. The driver is located in the same folder as "Profile" directory, but not inside the "Profile" directory.